Minimum Space - The entire length is normally mounted inside the housing face requiring only a flat pump mounting adaptor. The reduced space may result in savings within the equipment frame manufacture or hydraulic costs. Free Axial Travel - Crowned teeth slide freely in the nylon spline with a +/- 2mm axial travel. Any shaft float is absorbed within the coupling and is not transmitted to the pump components. Blind Assembly - Pump hub gear ring fits through the pilot hole of the pump mounting plate resulting in faster assembly at lower cost, therefore requiring no inspection ports or cut outs. Crowned Gear Teeth - Provides for angular misalignment, preventing angular force on the pump shaft bearings and seals. Heat Stable - Fibreglass reinforced nylon designed to operate in diesel engine ambients without air circulation. Dimensionally stable to 120°C. • Available in all hub sizes with parallel bores and metric or SAE splines • Maximum holding power without damage to pump spline. Easy removal • Hub length machined to meet minimum assembly requirements and available space. • Sintered steel hubs for excellent corrosion protection. • Simple, inexpensive, positive clamping. • Requires drilled and tapped pump shaft. • Available for SAE, metric or special splines and straight shafts with keyway. Cross-Bolt Clamping Pump Drive Components Bolt & Washer Clamping FL Couplings 33 #DriveLineHarmony www.jbj.co.uk/couplings.html
RkJQdWJsaXNoZXIy NzQyNjQ=