Mechanical Power Take-Off Units Models 6 #DriveLineHarmony PTO Model Number CX-106SP CX-107SP CX-108SP CX-110HP CX-111HP SP-111P SP-111HP SP-111OP SP-211HP SP-211OP SP-311P SP-114P SP-214P SP-214OP IB-214OP IB-214OP SP-314P SP-314P IB-314OP IB-314OP IB-314OP SP-218OP SP-218OP SP-318P IB-318OP IB-318OP IB-318OP SP-321P IB-321OP X8317 X8317 X8419A X8249 X8249 X9619 X9582 X9818 X9681 X9894B XA7570 X9643 X9803 X9845 X9745E X9745F X9585 X9585A XA7149 XA7149A XA7149B XA7190 XA7190A X9671 X9918 X9918A X9918B X9691A X9919 6,5,4 6,5,4 5,4,3 4,3,2,1 4,3,2,1 3,2,1 3,2,1 3,2 3,2,1 2,1 3,2,1 1,0 1,0 1,0 1,0 1,0 0,00 0 0 00 00 Class 1 215.58 (159) 237.27 (175) 311.84 (230) 444.71 (328) 524.70 (387) 616.90 (455) 1232.44 (909) 2196.46 (1620) 1098.21 (810) 2196.46 (1620) 3294.64 (2430) 4121.69 (3040) 5423.27 (4000) 8134.91 (6000) 10168.63 (7500) 9124.65 (6730) 11388.87 (8400) Class 2 29.83 (40) 40.27 (54) 45.49 (61) 71.59 (96) 92.47 (124) 92.47 (124) 184.19 (247) 276.66 (371) 140.19 (188) 280.38 (376) 295.00 (395) 420.58 (564) 3 552.56 (741) 695.74 (933) 695.74 (933) 912.74 (1224) 947.04 (1270) 3 1243.08 (1667) Class 3 20.13 (27) 26.85 (36) 30.57 (41) 47.72 (64) 61.15 (82) 61.15 (82) 123.04 (165) 184.19 (247) 93.21 (125) 187.17 (251) 196.87 (264) 280.38 (376) 368.38 (494) 309.47 (415) 463.83 (622) 3 608.49 (816) 631.61 (847) 3 828.47 (1111) Class 4 14.91 (20) 20.13 (27) 23.15 (31) 35.79 (48) 46.23 (62) 46.23 (62) 92.47 (124) 138.70 (186) 70.10 (94) 140.19 (188) 146.90 (197) 210.29 (282) 3 276.66 (371) 231.91 (311) 348.24 (467) 3 456.37 (612) 473.52 (635) 3 621.91 (834) Solid Plate Drive Ring 3500 3200 5 3100 5 3930 5 3600 5 3600 5 3500 5 3000 5 3000 5 3000 5 3000 5 2400 5 2400 3000 5 2400 1950 5 2350 5 2200 1800 5 2200 Drive Ring 3500 3200 5 3100 5 3500 5 3200 5 3200 5 3160 5 3000 NA 5 2750 5 2750 5 2400 NA 2700 NR 1550 5 2100 NR 1400 NR 24.04 (53) 24.95 (55) 32.66 (72) 52.16 (115) 54.43 (120) 58.51 (129) 63.96 (141) 65.77 (145) 70.31 (155) 79.38 (175) 99.79 (220) 117.9 (260) 148.78 (328) 154.22 (340) 213.18 (470) 185.06 (408) 269.89 (595) 299.37 (660) 317.52 (700) 417.31 (920) 503.49 (1110) 548.85 (1210) Notes: 1. NA (Not available). NR (Not recommended). 2. kWand torque ratings may be increased by specifying optional sintered iron-type clutch plates.Available SAE 8 through SAE 21 sizes. 3. Sintered iron clutch plates with ventilated-type centre plates are standard in IBF-314, IBF-318 and IBF-321 PTO units. These plates should not be used in applications where torsion or vibrations are prevalent. Consult jbj Techniques technical office, telephone: +44 (0)1737 767493 or email: info@jbj.co.uk 4. Compound drives and power-engaged PTO applications require written factory review for warranty to apply. 5. Nodular Iron. General information notes 1. Cap screws tomount PTO and driving ring to primemover are not Twin Disc supplied. 2. Installation of support plate to PTO housing requires bearing carrier cap screws be properly retorqued to prevent damage. Refer to applicable care and operation servicemanual. 3. Clutch maximum input torque values in specification chart is for properly adjusted clutch assemblies. Refer to applicable Care and Operation service manual. Important notice: Disregarding system torsional compatibility could cause damage to components in the drive train resulting in loss of mobility or power transmission for which the drive is intended. At minimum, system incompatibility could result in unwanted noise and vibration at low speeds. The responsibility for ensuring that the torsional compatibility of the system is satisfactory rests with the assembler of the drive and driven equipment. Torsional vibration analysis can be made by the engine builder, independent consultants and others. for Consult jbj Techniques technical office, telephone: +44 (0)1737 767493 or email: info@jbj.co.uk assistance in finding solutions to potential torsional problems that relate to the power take-off, pump mount PTO or rubber block drive. Drawing Assembly Number Housing Sizes SAE Maximum 2 Input Torque Nm (lb-ft) Approximate Net Weight kg (lbs) Clutch Maximum Power Rating (See note 2 below) kW (hp) Split Plates Application Duty Classification 1 Max. Safe Op. Speed (rpm) 2196.46 (1620) www.jbj.co.uk/mechanical-power-conversion.html
RkJQdWJsaXNoZXIy NzQyNjQ=